[proxmark3-svn] / armsrc / legicrf.c

/*
 * LEGIC RF simulation code
 *  
 * (c) 2009 Henryk Plötz <henryk@ploetzli.ch>
 */

#include <proxmark3.h>

#include "apps.h"
#include "legicrf.h"
#include <stdint.h>

#include "legic_prng.h"
#include "crc.h"

static struct legic_frame {
        int bits;
        uint32_t data;
} current_frame;

static crc_t legic_crc;

AT91PS_TC timer;

static void setup_timer(void)
{
        /* Set up Timer 1 to use for measuring time between pulses. Since we're bit-banging
         * this it won't be terribly accurate but should be good enough.
         */
        AT91C_BASE_PMC->PMC_PCER = (1 << AT91C_ID_TC1);
        timer = AT91C_BASE_TC1;
        timer->TC_CCR = AT91C_TC_CLKDIS;
        timer->TC_CMR = TC_CMR_TCCLKS_TIMER_CLOCK3;
        timer->TC_CCR = AT91C_TC_CLKEN | AT91C_TC_SWTRG;

/* At TIMER_CLOCK3 (MCK/32) */
#define RWD_TIME_1 150     /* RWD_TIME_PAUSE off, 80us on = 100us */
#define RWD_TIME_0 90      /* RWD_TIME_PAUSE off, 40us on = 60us */
#define RWD_TIME_PAUSE 30  /* 20us */
#define RWD_TIME_FUZZ 20   /* rather generous 13us, since the peak detector + hysteresis fuzz quite a bit */
#define TAG_TIME_BIT 150   /* 100us for every bit */
#define TAG_TIME_WAIT 490  /* time from RWD frame end to tag frame start, experimentally determined */

}

#define FUZZ_EQUAL(value, target, fuzz) ((value) > ((target)-(fuzz)) && (value) < ((target)+(fuzz)))

/* Send a frame in reader mode, the FPGA must have been set up by
 * LegicRfReader
 */
static void frame_send_rwd(uint32_t data, int bits)
{
        /* Start clock */
        timer->TC_CCR = AT91C_TC_CLKEN | AT91C_TC_SWTRG;
        while(timer->TC_CV > 1) ; /* Wait till the clock has reset */
        
        int i;
        for(i=0; i<bits; i++) {
                int starttime = timer->TC_CV;
                int pause_end = starttime + RWD_TIME_PAUSE, bit_end;
                int bit = data & 1;
                data = data >> 1;

                if(bit ^ legic_prng_get_bit()) {
                        bit_end = starttime + RWD_TIME_1;
                } else {
                        bit_end = starttime + RWD_TIME_0;
                }
                
                /* RWD_TIME_PAUSE time off, then some time on, so that the complete bit time is
                 * RWD_TIME_x, where x is the bit to be transmitted */
                AT91C_BASE_PIOA->PIO_CODR = GPIO_SSC_DOUT;
                while(timer->TC_CV < pause_end) ;
                AT91C_BASE_PIOA->PIO_SODR = GPIO_SSC_DOUT;
                legic_prng_forward(1); /* bit duration is longest. use this time to forward the lfsr */
                
                while(timer->TC_CV < bit_end) ;
        }
        
        {
                /* One final pause to mark the end of the frame */
                int pause_end = timer->TC_CV + RWD_TIME_PAUSE;
                AT91C_BASE_PIOA->PIO_CODR = GPIO_SSC_DOUT;
                while(timer->TC_CV < pause_end) ;
                AT91C_BASE_PIOA->PIO_SODR = GPIO_SSC_DOUT;
        }
        
        /* Reset the timer, to measure time until the start of the tag frame */
        timer->TC_CCR = AT91C_TC_SWTRG;
        while(timer->TC_CV > 1) ; /* Wait till the clock has reset */
}

/* Receive a frame from the card in reader emulation mode, the FPGA and
 * timer must have been set up by LegicRfReader and frame_send_rwd.
 * 
 * The LEGIC RF protocol from card to reader does not include explicit
 * frame start/stop information or length information. The reader must
 * know beforehand how many bits it wants to receive. (Notably: a card
 * sending a stream of 0-bits is indistinguishable from no card present.)
 * 
 * Receive methodology: There is a fancy correlator in hi_read_rx_xcorr, but
 * I'm not smart enough to use it. Instead I have patched hi_read_tx to output
 * the ADC signal with hysteresis on SSP_DIN. Bit-bang that signal and look
 * for edges. Count the edges in each bit interval. If they are approximately
 * 0 this was a 0-bit, if they are approximately equal to the number of edges
 * expected for a 212kHz subcarrier, this was a 1-bit. For timing we use the
 * timer that's still running from frame_send_rwd in order to get a synchronization
 * with the frame that we just sent.
 * 
 * FIXME: Because we're relying on the hysteresis to just do the right thing 
 * the range is severely reduced (and you'll probably also need a good antenna).
 * So this should be fixed some time in the future for a proper receiver. 
 */
static void frame_receive_rwd(struct legic_frame * const f, int bits, int crypt)
{
        uint32_t the_bit = 1;  /* Use a bitmask to save on shifts */
        uint32_t data=0;
        int i, old_level=0, edges=0;
        int next_bit_at = TAG_TIME_WAIT;
        
        
        if(bits > 16)
                bits = 16;

        AT91C_BASE_PIOA->PIO_ODR = GPIO_SSC_DIN;
        AT91C_BASE_PIOA->PIO_PER = GPIO_SSC_DIN;

        /* we have some time now, precompute the cipher
         * since we cannot compute it on the fly while reading */
        legic_prng_forward(2);

        if(crypt)
        {
                for(i=0; i<bits; i++) {
                        data |= legic_prng_get_bit() << i;
                        legic_prng_forward(1);
                }
        }

        while(timer->TC_CV < next_bit_at) ;

        next_bit_at += TAG_TIME_BIT;
        
        for(i=0; i<bits; i++) {
                edges = 0;

                while(timer->TC_CV < next_bit_at) {
                        int level = (AT91C_BASE_PIOA->PIO_PDSR & GPIO_SSC_DIN);
                        if(level != old_level)
                                edges++;
                        old_level = level;
                }
                next_bit_at += TAG_TIME_BIT;
                
                if(edges > 20 && edges < 60) { /* expected are 42 edges */
                        data ^= the_bit;
                }

                the_bit <<= 1;
        }
        
        f->data = data;
        f->bits = bits;
        
        /* Reset the timer, to synchronize the next frame */
        timer->TC_CCR = AT91C_TC_SWTRG;
        while(timer->TC_CV > 1) ; /* Wait till the clock has reset */
}

static void frame_clean(struct legic_frame * const f)
{
        f->data = 0;
        f->bits = 0;
}

static uint32_t perform_setup_phase_rwd(int iv)
{
        
        /* Switch on carrier and let the tag charge for 1ms */
        AT91C_BASE_PIOA->PIO_SODR = GPIO_SSC_DOUT;
        SpinDelay(1);
        
        legic_prng_init(0); /* no keystream yet */
        frame_send_rwd(iv, 7);
        legic_prng_init(iv);
        
        frame_clean(&current_frame);
        frame_receive_rwd(&current_frame, 6, 1);
        legic_prng_forward(1); /* we wait anyways */
        while(timer->TC_CV < 387) ; /* ~ 258us */
        frame_send_rwd(0x19, 6);

        return current_frame.data;
}

static void LegicCommonInit(void) {
        SetAdcMuxFor(GPIO_MUXSEL_HIPKD);
        FpgaSetupSsc();
        FpgaWriteConfWord(FPGA_MAJOR_MODE_HF_READER_TX);
        
        /* Bitbang the transmitter */
        AT91C_BASE_PIOA->PIO_CODR = GPIO_SSC_DOUT;
        AT91C_BASE_PIOA->PIO_OER = GPIO_SSC_DOUT;
        AT91C_BASE_PIOA->PIO_PER = GPIO_SSC_DOUT;
        
        setup_timer();
        
        crc_init(&legic_crc, 4, 0x19 >> 1, 0x5, 0);
}

static void switch_off_tag_rwd(void)
{
        /* Switch off carrier, make sure tag is reset */
        AT91C_BASE_PIOA->PIO_CODR = GPIO_SSC_DOUT;
        SpinDelay(10);
        
        WDT_HIT();
}
/* calculate crc for a legic command */
static int LegicCRC(int byte_index, int value, int cmd_sz) {
        crc_clear(&legic_crc);
        crc_update(&legic_crc, 1, 1); /* CMD_READ */
        crc_update(&legic_crc, byte_index, cmd_sz-1);
        crc_update(&legic_crc, value, 8);
        return crc_finish(&legic_crc);
}

int legic_read_byte(int byte_index, int cmd_sz) {
        int byte;

        legic_prng_forward(4); /* we wait anyways */
        while(timer->TC_CV < 387) ; /* ~ 258us + 100us*delay */

        frame_send_rwd(1 | (byte_index << 1), cmd_sz);
        frame_clean(&current_frame);

        frame_receive_rwd(&current_frame, 12, 1);

        byte = current_frame.data & 0xff;
        if( LegicCRC(byte_index, byte, cmd_sz) != (current_frame.data >> 8) ) {
                Dbprintf("!!! crc mismatch: expected %x but got %x !!!", LegicCRC(byte_index, current_frame.data & 0xff, cmd_sz), current_frame.data >> 8);
                return -1;
        }

        return byte;
}

/* legic_write_byte() is not included, however it's trivial to implement
 * and here are some hints on what remains to be done:
 *
 *  * assemble a write_cmd_frame with crc and send it
 *  * wait until the tag sends back an ACK ('1' bit unencrypted)
 *  * forward the prng based on the timing
 */


void LegicRfReader(int offset, int bytes) {
        int byte_index=0, cmd_sz=0, card_sz=0;
        
        LegicCommonInit();

        memset(BigBuf, 0, 1024);
        
        DbpString("setting up legic card");
        uint32_t tag_type = perform_setup_phase_rwd(0x55);
        switch(tag_type) {
                case 0x1d:
                        DbpString("MIM 256 card found, reading card ...");
                        cmd_sz = 9;
                        card_sz = 256;
                        break;
                case 0x3d:
                        DbpString("MIM 1024 card found, reading card ...");
                        cmd_sz = 11;
                        card_sz = 1024;
                        break;
                default:
                        Dbprintf("Unknown card format: %x",tag_type);
                        switch_off_tag_rwd();
                        return;
        }
        if(bytes == -1) {
                bytes = card_sz;
        }
        if(bytes+offset >= card_sz) {
                bytes = card_sz-offset;
        }

        switch_off_tag_rwd(); //we lost to mutch time with dprintf
        perform_setup_phase_rwd(0x55);

        while(byte_index < bytes) {
                int r = legic_read_byte(byte_index+offset, cmd_sz);
                if(r == -1) {
                        Dbprintf("aborting");
                        switch_off_tag_rwd();
                        return;
                }
                ((uint8_t*)BigBuf)[byte_index] = r;
                byte_index++;
        }
        switch_off_tag_rwd();
        Dbprintf("Card read, use 'hf legic decode' or 'data hexsamples %d' to view results", (bytes+7) & ~7);
}