git.zerfleddert.de Git - proxmark3-svn/blob - fpga/fpga_hf.v

   1 //-----------------------------------------------------------------------------
   2 // The FPGA is responsible for interfacing between the A/D, the coil drivers,
   3 // and the ARM. In the low-frequency modes it passes the data straight
   4 // through, so that the ARM gets raw A/D samples over the SSP. In the high-
   5 // frequency modes, the FPGA might perform some demodulation first, to
   6 // reduce the amount of data that we must send to the ARM.
   7 //
   8 // I am not really an FPGA/ASIC designer, so I am sure that a lot of this
   9 // could be improved.
  10 //
  11 // Jonathan Westhues, March 2006
  12 // Added ISO14443-A support by Gerhard de Koning Gans, April 2008
  13 // iZsh <izsh at fail0verflow.com>, June 2014
  14 //-----------------------------------------------------------------------------
  15
  16
  17 // Defining commands, modes and options. This must be aligned to the definitions in fpgaloader.h
  18 // Note: the definitions here are without shifts
  19
  20 // Commands:
  21 `define FPGA_CMD_SET_CONFREG                        1
  22 `define FPGA_CMD_TRACE_ENABLE                       2
  23
  24 // Major modes:
  25 `define FPGA_MAJOR_MODE_LF_ADC                      0
  26 `define FPGA_MAJOR_MODE_LF_EDGE_DETECT              1
  27 `define FPGA_MAJOR_MODE_LF_PASSTHRU                 2
  28 `define FPGA_MAJOR_MODE_HF_READER                   0
  29 `define FPGA_MAJOR_MODE_HF_SIMULATOR                1
  30 `define FPGA_MAJOR_MODE_HF_ISO14443A                2
  31 `define FPGA_MAJOR_MODE_HF_SNOOP                    3
  32 `define FPGA_MAJOR_MODE_HF_GET_TRACE                4
  33 `define FPGA_MAJOR_MODE_OFF                         7
  34
  35 // Options for the generic HF reader
  36 `define FPGA_HF_READER_MODE_RECEIVE_IQ              0
  37 `define FPGA_HF_READER_MODE_RECEIVE_AMPLITUDE       1
  38 `define FPGA_HF_READER_MODE_RECEIVE_PHASE           2
  39 `define FPGA_HF_READER_MODE_SEND_FULL_MOD           3
  40 `define FPGA_HF_READER_MODE_SEND_SHALLOW_MOD        4
  41 `define FPGA_HF_READER_MODE_SNIFF_IQ                5
  42 `define FPGA_HF_READER_MODE_SNIFF_AMPLITUDE         6
  43 `define FPGA_HF_READER_MODE_SNIFF_PHASE             7
  44 `define FPGA_HF_READER_MODE_SEND_JAM                8
  45 `define FPGA_HF_READER_SUBCARRIER_848_KHZ           0
  46 `define FPGA_HF_READER_SUBCARRIER_424_KHZ           1
  47 `define FPGA_HF_READER_SUBCARRIER_212_KHZ           2
  48
  49 // Options for the HF simulated tag, how to modulate
  50 `define FPGA_HF_SIMULATOR_NO_MODULATION             0
  51 `define FPGA_HF_SIMULATOR_MODULATE_BPSK             1
  52 `define FPGA_HF_SIMULATOR_MODULATE_212K             2
  53 `define FPGA_HF_SIMULATOR_MODULATE_424K             4
  54 `define FPGA_HF_SIMULATOR_MODULATE_424K_8BIT        5
  55
  56 // Options for ISO14443A
  57 `define FPGA_HF_ISO14443A_SNIFFER                   0
  58 `define FPGA_HF_ISO14443A_TAGSIM_LISTEN             1
  59 `define FPGA_HF_ISO14443A_TAGSIM_MOD                2
  60 `define FPGA_HF_ISO14443A_READER_LISTEN             3
  61 `define FPGA_HF_ISO14443A_READER_MOD                4
  62
  63 `include "hi_reader.v"
  64 `include "hi_simulate.v"
  65 `include "hi_iso14443a.v"
  66 `include "hi_sniffer.v"
  67 `include "hi_get_trace.v"
  68 `include "util.v"
  69
  70 module fpga_hf(
  71         input spck, output miso, input mosi, input ncs,
  72         input pck0, input ck_1356meg, input ck_1356megb,
  73         output pwr_lo, output pwr_hi,
  74         output pwr_oe1, output pwr_oe2, output pwr_oe3, output pwr_oe4,
  75         input [7:0] adc_d, output adc_clk, output adc_noe,
  76         output ssp_frame, output ssp_din, input ssp_dout, output ssp_clk,
  77         input cross_hi, input cross_lo,
  78         output dbg
  79 );
  80
  81 //-----------------------------------------------------------------------------
  82 // The SPI receiver. This sets up the configuration word, which the rest of
  83 // the logic looks at to determine how to connect the A/D and the coil
  84 // drivers (i.e., which section gets it). Also assign some symbolic names
  85 // to the configuration bits, for use below.
  86 //-----------------------------------------------------------------------------
  87
  88 reg [15:0] shift_reg;
  89 reg [8:0] conf_word;
  90 reg trace_enable;
  91
  92 // We switch modes between transmitting to the 13.56 MHz tag and receiving
  93 // from it, which means that we must make sure that we can do so without
  94 // glitching, or else we will glitch the transmitted carrier.
  95 always @(posedge ncs)
  96 begin
  97         case(shift_reg[15:12])
  98                 `FPGA_CMD_SET_CONFREG:  conf_word <= shift_reg[8:0];
  99                 `FPGA_CMD_TRACE_ENABLE: trace_enable <= shift_reg[0];
 100         endcase
 101 end
 102
 103 always @(posedge spck)
 104 begin
 105         if(~ncs)
 106         begin
 107                 shift_reg[15:1] <= shift_reg[14:0];
 108                 shift_reg[0] <= mosi;
 109         end
 110 end
 111
 112 // select module (outputs) based on major mode
 113 wire [2:0] major_mode = conf_word[8:6];
 114
 115 // configuring the HF reader
 116 wire [1:0] subcarrier_frequency = conf_word[5:4];
 117 wire [3:0] minor_mode = conf_word[3:0];
 118
 119 //-----------------------------------------------------------------------------
 120 // And then we instantiate the modules corresponding to each of the FPGA's
 121 // major modes, and use muxes to connect the outputs of the active mode to
 122 // the output pins.
 123 //-----------------------------------------------------------------------------
 124
 125 hi_reader hr(
 126         ck_1356megb,
 127         hr_pwr_lo, hr_pwr_hi, hr_pwr_oe1, hr_pwr_oe2, hr_pwr_oe3, hr_pwr_oe4,
 128         adc_d, hr_adc_clk,
 129         hr_ssp_frame, hr_ssp_din, ssp_dout, hr_ssp_clk,
 130         hr_dbg,
 131         subcarrier_frequency, minor_mode
 132 );
 133
 134 hi_simulate hs(
 135         ck_1356meg,
 136         hs_pwr_lo, hs_pwr_hi, hs_pwr_oe1, hs_pwr_oe2, hs_pwr_oe3, hs_pwr_oe4,
 137         adc_d, hs_adc_clk,
 138         hs_ssp_frame, hs_ssp_din, ssp_dout, hs_ssp_clk,
 139         hs_dbg,
 140         minor_mode
 141 );
 142
 143 hi_iso14443a hisn(
 144         ck_1356meg,
 145         hisn_pwr_lo, hisn_pwr_hi, hisn_pwr_oe1, hisn_pwr_oe2, hisn_pwr_oe3, hisn_pwr_oe4,
 146         adc_d, hisn_adc_clk,
 147         hisn_ssp_frame, hisn_ssp_din, ssp_dout, hisn_ssp_clk,
 148         hisn_dbg,
 149         minor_mode
 150 );
 151
 152 hi_sniffer he(
 153         ck_1356megb,
 154         he_pwr_lo, he_pwr_hi, he_pwr_oe1, he_pwr_oe2, he_pwr_oe3, he_pwr_oe4,
 155         adc_d, he_adc_clk,
 156         he_ssp_frame, he_ssp_din, he_ssp_clk
 157 );
 158
 159 hi_get_trace gt(
 160         ck_1356megb,
 161         adc_d, trace_enable, major_mode,
 162         gt_ssp_frame, gt_ssp_din, gt_ssp_clk
 163 );
 164
 165 // Major modes:
 166
 167 //   000 --  HF reader; subcarrier frequency and modulation depth selectable
 168 //   001 --  HF simulated tag
 169 //   010 --  HF ISO14443-A
 170 //   011 --  HF Snoop
 171 //   100 --  HF get trace
 172 //   111 --  everything off
 173
 174 mux8 mux_ssp_clk        (major_mode, ssp_clk,   hr_ssp_clk,   hs_ssp_clk,   hisn_ssp_clk,   he_ssp_clk,   gt_ssp_clk,   1'b0, 1'b0, 1'b0);
 175 mux8 mux_ssp_din        (major_mode, ssp_din,   hr_ssp_din,   hs_ssp_din,   hisn_ssp_din,   he_ssp_din,   gt_ssp_din,   1'b0, 1'b0, 1'b0);
 176 mux8 mux_ssp_frame      (major_mode, ssp_frame, hr_ssp_frame, hs_ssp_frame, hisn_ssp_frame, he_ssp_frame, gt_ssp_frame, 1'b0, 1'b0, 1'b0);
 177 mux8 mux_pwr_oe1        (major_mode, pwr_oe1,   hr_pwr_oe1,   hs_pwr_oe1,   hisn_pwr_oe1,   he_pwr_oe1,   1'b0,         1'b0, 1'b0, 1'b0);
 178 mux8 mux_pwr_oe2        (major_mode, pwr_oe2,   hr_pwr_oe2,   hs_pwr_oe2,   hisn_pwr_oe2,   he_pwr_oe2,   1'b0,         1'b0, 1'b0, 1'b0);
 179 mux8 mux_pwr_oe3        (major_mode, pwr_oe3,   hr_pwr_oe3,   hs_pwr_oe3,   hisn_pwr_oe3,   he_pwr_oe3,   1'b0,         1'b0, 1'b0, 1'b0);
 180 mux8 mux_pwr_oe4        (major_mode, pwr_oe4,   hr_pwr_oe4,   hs_pwr_oe4,   hisn_pwr_oe4,   he_pwr_oe4,   1'b0,         1'b0, 1'b0, 1'b0);
 181 mux8 mux_pwr_lo         (major_mode, pwr_lo,    hr_pwr_lo,    hs_pwr_lo,    hisn_pwr_lo,    he_pwr_lo,    1'b0,         1'b0, 1'b0, 1'b0);
 182 mux8 mux_pwr_hi         (major_mode, pwr_hi,    hr_pwr_hi,    hs_pwr_hi,    hisn_pwr_hi,    he_pwr_hi,    1'b0,         1'b0, 1'b0, 1'b0);
 183 mux8 mux_adc_clk        (major_mode, adc_clk,   hr_adc_clk,   hs_adc_clk,   hisn_adc_clk,   he_adc_clk,   1'b0,         1'b0, 1'b0, 1'b0);
 184 mux8 mux_dbg            (major_mode, dbg,       hr_dbg,       hs_dbg,       hisn_dbg,       1'b0,         1'b0,         1'b0, 1'b0, 1'b0);
 185
 186 // In all modes, let the ADC's outputs be enabled.
 187 assign adc_noe = 1'b0;
 188
 189 // not used
 190 assign miso = 1'b0;
 191
 192 endmodule